Why do you insist on tagging native VLAN? If there is no special reason to do it, don't :-)
Solution for your problem is to make some other (unused) VLAN native on the 2950. That way, it will tag VLAN 1 over the trunk. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mark Tohill Sent: fimmtudagur, 3. maí 2007. 09:38 To: [email protected] Subject: [c-nsp] 802.1q trunking from cat6509 to 2950T-24 Hi, I am having difficulty establishing 802.1q trunk to 2950 switch. I am only (initailly) trying to establish VLAN1 across trunk. I have 'vlan dot1q tag native' configured on the 6509 side but I dont have a similar command on 2950T-24 or a way to untag the native on a per trunk basis on the 6509. Configs below: 6509: ! vtp mode transparent vlan dot1q tag native ! interface GigabitEthernet1/14 description 802.1q Switch1 Access switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan 1-599,601-4094 switchport mode trunk switchport nonegotiate no ip address logging event link-status 2950T-24: ! vtp mode transparent ! interface GigabitEthernet0/1 description 802.1q<-->-6509-01[Gig1/14] switchport trunk allowed vlan 1-599,601-4094 switchport mode trunk switchport nonegotiate no ip address Am I missing something? Thanks, Mark Mark Tohill UTV Internet T:+44 (0)28 90 262196 M:+44 (0)7786 278716 E:[EMAIL PROTECTED] <blocked::mailto:[EMAIL PROTECTED]> _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
