Hi, GLC-T interface is 1000BaseT-only. You cannot connect 100BaseT devices here. On 3560 you have 10/100/1000 ports.
On 05/11/2007 11:04 AM, saso pirnat wrote: > Does anybody knows why i can't get line protocol up with sfp GLC-T on > cisco7609 WS-SUP720-3BXL and line card WS-X6748-SFP when I try to > connect with some other equipment that supports only 100Mb/FD. Auto > negotiation is on. When I connect with same equipment to other switches > like C3560 the line protocol is established. > > sh int on 7609 > GigabitEthernet1/7 is down, line protocol is down (notconnect) > Hardware is C6k 1000Mb 802.3, address is 000a.b8de.1ac6 (bia > 000a.b8de.1ac6) > Description: > MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation ARPA, loopback not set > Keepalive set (10 sec) > Full-duplex, 1000Mb/s, media type is T > input flow-control is off, output flow-control is desired > Clock mode is auto > ARP type: ARPA, ARP Timeout 04:00:00 > Last input never, output never, output hang never > Last clearing of "show interface" counters never > Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: fifo > Output queue: 0/40 (size/max) > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 0 packets input, 0 bytes, 0 no buffer > Received 0 broadcasts (0 multicasts) > 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored > 0 watchdog, 0 multicast, 0 pause input > 0 input packets with dribble condition detected > 0 packets output, 0 bytes, 0 underruns > 0 output errors, 0 collisions, 3 interface resets > 0 babbles, 0 late collision, 0 deferred > 0 lost carrier, 0 no carrier, 0 PAUSE output > 0 output buffer failures, 0 output buffers swapped out1 > > > > sh int on 3560 > GigabitEthernet0/2 is up, line protocol is up (connected) > Hardware is Gigabit Ethernet, address is 0016.9d34.5482 (bia > 0016.9d34.5482) > MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation ARPA, loopback not set > Keepalive not set > Full-duplex, 100Mb/s, link type is auto, media type is > 10/100/1000BaseTX SFP > input flow-control is off, output flow-control is unsupported > ARP type: ARPA, ARP Timeout 04:00:00 > Last input never, output 00:00:00, output hang never > Last clearing of "show interface" counters never > Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: fifo > Output queue: 0/40 (size/max) > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 0 packets input, 0 bytes, 0 no buffer > Received 0 broadcasts (0 multicast) > 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored > 0 watchdog, 0 multicast, 0 pause input > 0 input packets with dribble condition detected > 4501 packets output, 595675 bytes, 0 underruns > 0 output errors, 0 collisions, 2 interface resets > 0 babbles, 0 late collision, 0 deferred > 0 lost carrier, 0 no carrier, 0 PAUSE output > 0 output buffer failures, 0 output buffers swapped out > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ -- __________________________________________________________________ NIX.CZ z.s.p.o. email: [EMAIL PROTECTED] Daniel Suchy, technical specialist tel: +4202 67198350 Nad Elektrarnou 411, Prague 10 fax: +4202 67198349 106 00 Czech Republic http://www.nix.cz _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
