> -----Original Message----- > From: [EMAIL PROTECTED] [mailto:cisco-nsp- > [EMAIL PROTECTED] On Behalf Of Paul Stewart > Sent: Monday, May 14, 2007 5:37 PM > To: [email protected] > Subject: [c-nsp] Access-list Question > > Ok... I know I had a rough weekend but I don't get this.. > > Creating a new access-list for an interface on a 2621 router: > > access-list 100 permit ip host xxx.xxx.xxx.64 yyy.yyy.yyy.64 > 255.255.255.192 > > I want to permit access from one particular host to the yyy.yyy.yyy.64/26 > subnet... > > When I do a "show run" I see this: > > access-list 100 permit ip host xxx.xxx.xxx.64 0.0.0.0 255.255.255.192 >
You need to use the wild card mask instead access-list 100 permit ip host xxx.xxx.xxx.64 yyy.yyy.yyy.64 0.0.0.63 Regards, Peter > > Why? ;) > > Thanks, > > Paul > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
