We are replacing a 3640 with a 3845. The 3640 runs an ISDN PRI line in a NM-1FE2CE1B. Since xCE1B modules are not supported in 3845 we have changed to VWIC-2MFT-E1. When I try to enter the command "pri-group timeslots 1-31" under the E1 controller I get this error: % Not enough DSP resources available to configure pri-group on controller E1 0/0/0 % The remaining dsp resources are enough for 0 time slots. % For current codec complexity, 2 extra dsp(s) are required to create this voice port.
I have searched ciscos web and googled, but I can't find the solution to this. I have tried moving the VWIC from slot 0 to slot 1, but same problem there. Isn't it possible to enter pri-group on VWIC-2MFT-E1? In that case, what alternatives are there to enable pri-group on an E1 controller in 3845? The isdn switch-type is primary-net5. I found "voice-card 0" in the configuration and I have tried enabling "dsp tdm pooling" under "voice-card 0", but it doesn't help. The IOS in the 3845 is rather old, c3845-advipservicesk9-mz.124-3f, so I will upgrade and try again, but I'm afraid it won't help. Thanks! -- Peter Olsson [EMAIL PROTECTED] _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
