Works fine on all Cisco gear. PRU-CORE01>sho ip int brie | i Mu Multilink1 192.168.141.29 YES NVRAM up up Multilink2 192.168.141.50 YES NVRAM up up PRU-CORE01>ping 192.168.141.29
Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.141.29, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 100/103/104 ms PRU-CORE01>sho ver | i IOS IOS (tm) s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-VM), Version 12.2(18)SXF9, RELEASE SOFTWARE (fc1) PRU-CORE01> -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Zhao, Wenmei (Sarah) Sent: Friday, August 24, 2007 3:19 PM To: Alex Balashov Cc: [email protected] Subject: Re: [c-nsp] cannot ping MLPPP local IP address Hi Alex, Yes, I did extended ping, but the result was the same. The local MLPPP IP is on the same subnet as the remote IP, and the route is in the routing table. So it's <supposed to> work. This behavior is not observed in a Juniper router with similar configuration. So I thought it's something specific to Cisco. Regards, Sarah Zhao The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
