Hi I have purchsed 1841 with same wic module .Is this below config work for point to point T1 connection. interface Serial0/0
ip address service-module t1 framing esf service-module t1 linecode b8zs service-module t1 timeslots 1-12 speed 64 Regards Gagandeep Jay Hennigan <[EMAIL PROTECTED]> wrote: joe mcguckin wrote: > I can't get this combination to bring up a T1. > > Configured as > encaps hdlc > service-module t1 clock source line > service-module t1 line b8zs > service-module t1 frame esf > service-module t1 timeslots all > > Indicator LED on WIC is green, with no alarms. Look closely at the jack on the WIC, the molded plastic on the back of where the plug inserts. Does it read "STEWART"? If not, you have a fake WIC. Even if it does, you might have a fake. -- Jay Hennigan - CCIE #7880 - Network Engineering - [EMAIL PROTECTED] Impulse Internet Service - http://www.impulse.net/ Your local telephone and internet company - 805 884-6323 - WB6RDV _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ --------------------------------- Now you can chat without downloading messenger. Click here to know how. _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/