ip dhcp pool 0 import all network 10.0.0.0 255.255.255.0 default-router 10.0.0.1 dns-server <insert primary DNS server here> <insert secondary DNS server here>
interface fa 0/0 description NAT_OUTSIDE ip address negotiated ip nat outside interface fa 0/1 description NAT_INSIDE ip address 10.0.0.1 255.255.255.0 ip nat inside ip nat inside source list 100 interface FastEthernet 0/0 overload access-list 100 permit ip 10.0.0.0 0.0.0.255 any Casey that is the absolute bare bones configuration for a 2600 There are Cisco site pages dedicated to doing all of this, but to be honest, you really need a lot more than what I have offered in reality Moreover, you need to provide a "show version" if you want people to comment on whether an IOS versions supports a specific feature or not. My gut says though, that a 2600-NonXM with 12.2 is not going to have VPN support. Hope this helps you get started On Feb 5, 2008 1:46 AM, Casey Mills <[EMAIL PROTECTED]> wrote: > List > > I am new to Cisco and trying to get started. I have a 2611 router > with a couple ethernet ports to get started. I would like to set it > up for home use. DHCP client on one port, DHCP server on the other, > and NATing. Can someone point me to a website or send me a config. > > I would eventually like to have this router run a VPN so I can > remotely access my home network. Is this router capable of doing > that? I have 12.2 IOS on it. > > Thanks, > Casey > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
