First thing I tried after getting the err-disable :-) It works fine in the lab, but for production configuration I decided to stick with the GLC-T GBIC option and use CAB-SFP-50CM= for connectivity between 3560's only.
-----Original Message----- From: Robert Hass [mailto:[EMAIL PROTECTED] Sent: Tuesday, February 12, 2008 5:05 AM To: Tolstykh, Andrew Cc: [email protected] Subject: Re: [c-nsp] CAB-SFP-50CM= question On Feb 12, 2008 5:21 AM, Tolstykh, Andrew <[EMAIL PROTECTED]> wrote: > The interface will end up in the err-disabled state due to the > "unsupported gbic detected" message, at least that's what I got in the > lab when I attempted to interconnect 3560's and 3750's with 2960's. Can you try to add below commands: service unsupported-transceiver no errdisable detect cause gbic-invalid no errdisable detect cause sfp-config-mismatch and interconnect above switches again ? Robert The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
