Cassidy, Take a look at CSCei46978 - http://mysolvr.com/?show=1.15418 . The fixes for i46978 should be in 12.4 mainline hence you may give it a shot.
Out of curiosity, if all your 7200s with NPE-G1s run the same IOS release and the only difference is the NPE rev, what happens when you swap this C-rev NPE with an A-rev NPE? Do the errors persist on this chassis or do they 'follow 'the C-rev NPE? /eninja On Sat, Feb 9, 2008 at 11:58 PM, <[EMAIL PROTECTED]> wrote: > I moved a bunch of PPPoE sessions over to a 7200 with a new NPE-G1 this > evening. > > Every 30 minutes or so I get an error similar to this: > > Feb 10 00:47:43 MST: %SBETH-3-ERRINT: GigabitEthernet0/2, error interrupt, > mac_status = 0x0000000000840000 > > Seen it on both G0/1 and G0/2. Unfortunately, this causes my OSPF > sessions > to bounce for a few seconds causing some grief. > > Currently running C7200-ADVENTERPRISEK9-M on 12.4(6)T10, but have also > tried > 12.4(9)T7, 12.4(15)T3 and 12.4(15)T1. > > Anybody have any clues? I almost at wits end. > > Appears this NPE-G1 is a "revision C". My other NPE-G1's are "revision A" > and do not exhibit this issue. > > Thanks, > > Cassidy > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
