Grant Moerschel wrote: > Therefore is it accurate to say that if I want the 3560 > to be a Layer 2 device only I have to: > - disable ip routing and eigrp > - define a management interface (the current VLAN1 SVI) > - default-gateway for the management vlan on the 3560 > - trunk as described above
Yes. > Or if I want the 3560 to be a Layer 3 device I have to: > - enable IP routing > - enable EIGRP consistent with the core router > - choose an completely different VLAN for the access > switches and give them an SVI at the access switch and > let EIGRP handle the routing (??) This would work, or you could run a hybrid setup with some switched VLANs and some routed VLANs. IMNSHO, KISS. If you want Layer 2 to the edge then unless you have a compelling reason to do otherwise, disable routing on the 3560. Regards, Brad _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
