Hi folks... if there is a better place to ask than here please let me know...;)
I have a Cisco 871 at a client site with a 2 meg connection. We built a site to site VPN (config below) which works perfectly... now the client would like 4-5 remote access VPN sessions to be possible. I'm asking the list before I dive too much into docs on the easiest simple way to setup a remote access VPN when you already have a site to site configured.... we'd like to adopt a "cookie cutter" approach for some other client sites in the near future.... this particular customer has remote computers running Mac OS/X and PC's running XP/Vista which I understand the Cisco VPN client runs on both....? Can someone tell me a good way to configure both on the same router? Thanks in advance.. Paul Config: crypto isakmp policy 10 encr aes 256 authentication pre-share crypto isakmp key XXXXXXXXXXX address xx.xx.xx.xxx ! ! crypto ipsec transform-set ts1 ah-sha-hmac esp-aes 256 ! crypto ipsec profile VPN set transform-set ts1 interface Tunnel0 description xxxxxxxxxxx ip address 172.16.1.1 255.255.255.252 tunnel source FastEthernet4 tunnel destination xx.xx.xx.xxx tunnel protection ipsec profile VPN interface FastEthernet4 description Nexicom Cable ip address dhcp ip nat outside ip virtual-reassembly duplex auto speed auto no cdp enable ! interface Vlan1 description Internal LAN ip address 10.241.41.193 255.255.255.192 ip nat inside ip virtual-reassembly ip route 10.241.175.64 255.255.255.192 Tunnel0 ip nat inside source list 102 interface FastEthernet4 overload access-list 102 deny ip 10.241.41.192 0.0.0.63 10.241.175.64 0.0.0.63 access-list 102 permit ip 10.241.41.192 0.0.0.63 any _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
