Did you setup a port mirror on the switch the IPS was connected to to mirror traffic to the device?
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ibrahim Alsharif Sent: Tuesday, April 22, 2008 4:47 AM To: [email protected] Subject: [c-nsp] IPS 4240 hello Guys, I have 2 IPS to install in a network those 2 IPS i should install them in promiscuous mode for testing then change their work to inline mode according to inline mode i tried it in a lab environment and it did work fine, but in promiscuous mode i couldn't get any events on the sensor with the knowledge that the sensor interface that is connected to the network is in sensing mode & it's promiscuous, so please advice what to do & where should I put the IPS in my topology. thanks, ____________________________________________________________________________________ Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ Note: This message and any attachments is intended solely for the use of the individual or entity to which it is addressed and may contain information that is non-public, proprietary, legally privileged, confidential, and/or exempt from disclosure. If you are not the intended recipient, you are hereby notified that any use, dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the original sender immediately by telephone or return email and destroy or delete this message along with any attachments immediately. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
