On Fri, Apr 25, 2008 at 12:48 AM, Jason Berenson <[EMAIL PROTECTED]> wrote: > Sidney, > > I already got the G1 replaced, it's working. I have an NPE-400 in a VXR > chassis that was running fine with 12.3.x until I put 12.4.19 on it. It > starts the boot process, shows the version of bootstrap (12.2.x) then shows > the amount of memory (256M) then does this: > > rommon> > rommon> > rommon> > rommon> > rommon> > rommon> > ... > > It keeps scrolling rommon as if I had the enter key depressed. It even > does this if I put a flash card in the controller card with JUST 12.3.x IOS > on it. I've tried a few different controller cards a few different console > cables and a few different computers. I'm running out of options. I was > told to try upgrading to 12.4.22 but that version isn't on cisco's site. > When I call them they insist I need a smartnet contract before I can speak > to an engineer. They won't provide the new IOS. > Any ideas? > > Thanks, > Jason
What's happening if you boot the chassis without any PA inserted (remember OIR ie hot swap of PA is not supported on 7200 platform)? Sidney _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
