> -----Original Message----- > From: [EMAIL PROTECTED] [mailto:cisco-nsp- > [EMAIL PROTECTED] On Behalf Of Chad Whitten > Sent: Wednesday, May 14, 2008 9:10 AM > To: [email protected] > Subject: Re: [c-nsp] vlan tagging question > > Thanks for the reply. > > The device can understand 802.1q and can tag/untag frames. The cisco > is outside my control and I have very little experience with the > native vlan setting. My thinking is that the cisco config should be > something like > > switchport mode trunk > switchport trunk encapsulation dot1q > swtitchport allowed vlan 100,201 > (some of that syntax may not be correct) > > and that if I am doing tagging on the access device, the native vlan > part of the config is not needed >
Only seeing this part of the config, the switch will tag both 100 and 201 and allow these over the trunk. Whether or not 201 is *actually* tagged, I believe, depends on if the "vlan dot1q tag native" setting is configured on the Cisco *and* if "switchport trunk native vlan 201" is configured. -evt _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
