Hi Pablo, I think you should execute these commands in routed ports of cisco 1841.
router(config)#bridge 1 protocol ieee router(config)#bridge irb router(config)#int fa0/0 router(config-if)#bridge-group 1 router(config-if)#exit router(config)#int fa0/1 router(config-if)#bridge-group 1 router(config-if)#exit Regards, On Sat, Jun 7, 2008 at 10:40 AM, Pablo Almido <[EMAIL PROTECTED]> wrote: > Hi folks, I am trying configure simple bridging in a router 1841, because I > need that it works in mode bridge, I will put I firewall beetween this > router and ISP router, and I want to use QoS features of cisco router 1841, > it is possible configure in router cisco1841, how I can reach it? > > Router ISP --------- Router 1841 (bridge) ------------ Firewall > > I have execute the following commands, but I get a error. > > router(config)#bridge 1 protocol ieee > router(config)#bridge irb > router(config)#int fa0/0/0 > router(config-if)#bridge-group 1 > FastEthernet0/0/0 does not support bridging > router(config-if)#exit > > > thanks in advance. > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- "The network is the computer" _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
