6500 is very (very) different.
SearchCCO for 6500 QoS and then spend a couple of days reading and
re-reading. Lots of limitations as its done in switch hardware so your line
cards will determine whats possible and where.
----- Original Message -----
From: "Paul Stewart" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, June 10, 2008 10:02 AM
Subject: [c-nsp] QOS Problem - 6500 SVI Interface
I've ran across this before and can't remember..;)
6500 running native IOS and trying to apply QOS outbound on a VLAN SVI
interface:
dis1-rtr-pt(config-if)#service-policy output VOIP
MQC features are not supported in output direction for this interface
class-map match-any VOIP
description Voice Prioritization DSCP
match protocol rtp
match protocol sip
match protocol mgcp
policy-map VOIP
class VOIP
set dscp cs5
class class-default
set dscp default
This config works fine on subinterfaces with a 7206VXR . can someone tell
me
what's wrong for this on the 6500?
Best regards,
Paul
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
