We have a 6500 switch in our network with two SUP720 engines running in SSO mode. One engine is Active and the other is Standby HOT. Engines are located in slot 5 and slot 6.
We are also running NSF. I want to upgrade the engines to SUP720-3BXLs without taking the switch off line. Both of the new engines have the necessary IOS on them. What I was hoping to do was pull engine 2 out of slot 6, install one of the new SUP720-3BXLs, wait for it to boot, then issue a wr m command on the Active engine to sync the configuration to the new standby and then fail over to engine 2 and do the same thing to engine 1 in slot 5. I cannot seem to find instructions or advice as to if this will work or not and figured I would shoot it out here before calling the TAC to see what they say. I have seen the upgrade from SUP1 to SUP720, but not SUP720 to SUP720-3BXL. Any help/advice would be greatly appreciated. Cheers -=-=-=-=-=-=-=-=-=-=-=-=-=-=-= Richard J. Sears CCNP/CCDP/F5SE _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
