Hi All, What is the best way to configure a redundant setup with one Ethernet router and two layer 2 switches? This setup will have (1) Cisco 7206 and (2) Cisco 2924M XL one with GbE card and one without. This is for low services such as 1Mb to 10Mb. This customer wants to hand-off layer 2 to their customers with layer 3 being performed on the c7206. I have looked at DTP, HSRP, STP, and EtherChannel on this low-end gear but not sure yet, need advice. Could put in a Cisco 5509 as well if needed. Trying to figure out best solution with this old gear they have in closet.
Requirements: QoS 802.1Q for sub interfaces on 7206 Multi-VLAN Capability to handoff layer 2 only to customer. --rootnet08 _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
