According to my brand new knowledge of Bandwidth Points concept for 7200 in case of absence of other PAs in both chassis ur PA-2T3+ will consume 180 bp of 600 bp of selected bus at each router :O) Except jokes, as soon as ur configuration is supported I don't see any reason to make U unhappy with it even if multilinking of T3s would appear at processor level.
-- Respect, Andy Oleynik Telecom Dpt Chief BMS Consulting Ltd 10, Stritenska Str., of. 520 Kyiv, 01025, UA tel +380(44)4619961 tel +380(44)4619963 extn 162 fax +380(44)4619962 www.bms-consulting.com andyo> -----Original Message----- andyo> From: [EMAIL PROTECTED] [mailto:cisco-nsp- andyo> [EMAIL PROTECTED] On Behalf Of Jared Brown andyo> Sent: Friday, July 18, 2008 3:47 AM andyo> To: [email protected] andyo> Subject: [c-nsp] multilink ds3's andyo> andyo> Hello, andyo> I wanted to check to see if there would be any issue with andyo> multilinking 2 andyo> serial ds3's on a pa-2t3 card. I know the IOS supports it, but I andyo> was worried andyo> about all the overhead and the proc load. Each end would have a andyo> 7206vxr/npe-g1 and pa-2t3 cards. Thanks. andyo> andyo> Jared andyo> _______________________________________________ andyo> cisco-nsp mailing list [email protected] andyo> https://puck.nether.net/mailman/listinfo/cisco-nsp andyo> archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
