The tx-queue-limit I always saw was for the 75xx due to the QA asic forwarding. It set the memd txacc queues.
For the traditional boxes it's hold-queue out or tx ring. The tx ring is the fifo queue to the device driver. The hold-queue is where we back packets up when the tx ring is congested. That's if there isn't a QOS policy applied at which point you have queue-limit under the individual classes. ATM is a bit more complex with per VC queues. I'm not sure if they have a tx-queue-limit concept. Rodney On Tue, Jul 29, 2008 at 12:11:15AM +0300, Ibrahim Abo Zaid wrote: > Hi Rodeny > > Thanks for your reply , i think this isn't specific for a given platform but > it > is common on low-end CE routers especially with serial interfaces > > best regards > --Ibrahim > > On Sun, Jul 27, 2008 at 9:49 PM, Rodney Dunn <[EMAIL PROTECTED]> wrote: > > On what platform? > > On Sat, Jul 26, 2008 at 06:05:49PM +0300, Ibrahim Abo Zaid wrote: > > Hi All > > > > i am a bit confused between Interface queues that can be configured > using > > tx-queue-limit and hold-queue , what is the difference between these > queues > > ? > > > > > > appreciate your replies . > > > > best regards > > --Ibrahim > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
