Andreas Sikkema wrote:
How do I add 310 as a prefix to the calls from port 3/3 so that dialpeer
100 does not match and calls go to dialpeer 12 (or something functionally
similar)?
To add translations based on a specific physical port, you have to add
the translation profile to the voice-port for 3/3, so that the
translation can happen before any dial-peer matching is done (that's the
order of evaluation).
Example:
voice translation-rule 2
rule 1 /^\(.+\)/ /05500\1/
!
!
voice translation-profile FAX-TRANSLATIONS
translate called 2
!
...
!
voice-port 4/1:D
translation-profile incoming FAX-TRANSLATIONS
no comfort-noise
bearer-cap 3100Hz
!
...
!
dial-peer voice 803 voip
description FAX DIDs
destination-pattern 05500T
session protocol sipv2
session target ipv4:XXX.YYY.ZZZ.AAA
session transport udp
dtmf-relay rtp-nte
codec g711ulaw
fax rate 14400 bytes 255
fax protocol pass-through g711ulaw
no vad
--
This example stamps a prefix of 05500 on all calls that come in on T1
4/1, and then there is a dial peer that matches 05500 + anything. In
this case, it's a VoIP peer, but it doesn't have to be.
--
Alex Balashov
Evariste Systems
Web : http://www.evaristesys.com/
Tel : (+1) (678) 954-0670
Direct : (+1) (678) 954-0671
Mobile : (+1) (706) 338-8599
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
