What about 7200s? They're a bit big, but you can pick them up relatively
inexpensively these days (NPE300/225 should do you)
If you want something smaller, i'd almost always go for a 7301 over a 38xx.
adam.
Hi.
I'm trying to convince a friend not to use SDH-to-Ethernet mux and
instead go for a router-based solution, but I've only found ATM
network modules to go with 3xxx series routers.
What would the cheapest(new, used, refurbished, all of above) Cisco
gear that could:
1) On the remote sites, have STM-1 SDH connection; no sub-channeling,
just a single IP interface with all the STM-1 capacity.
2) On the central site, have STM-16 SDH connection; some channeling is
required, so each remote STM-1 is a sub-interface.
Tks,
Rubens
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
