Auto-mdix is disabled when you hard code speed/duplex. Check to make
sure cable is a crossover
-Brandon
Sent from my iPhone
On Nov 20, 2008, at 6:56 PM, Christopher Hunt <[EMAIL PROTECTED]>
wrote:
I have a cisco 3560 switch connected to a TelcoSystems EdgeGate 282
CPE switch provided by a local FTTx provider.
* Ethernet auto-negotiate works fine but,
* when the CPE at is hard-coded at 10/Full, and the 3560 at auto-
auto, I get 10/Half on the 3560 (that's to be expected).
* Auto-auto on both gets me 100/Full on both (also expected).
* 10/Full on both gets me nothing, link is down on both.
We have put in a service case with Telco Systems to see if there is
something we can do about it. Has anyone any experience with this
hardware?
--
Christopher Hunt
ReachONE Internet, Inc.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
