Moshe, Take a look at these command: http://www.cisco.com/en/US/docs/ios/iproute/command/reference/irp_bgp3.h tml#wp1012317
Arie -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of moshe mizrachi Sent: Thursday, November 27, 2008 15:27 PM To: cisco-nsp@puck.nether.net Subject: [c-nsp] load balance between to EBGP peers Hi all , i have MPLS/VPN network based on 7600's . all the Internet is going via VRF-INTERNET , my ASBR gets full route from 2 peers via OC12 POS interfaces on VRF INTERNET , also he gets 0.0.0.0 route from both peers but of course only 1 gets to FIB . my target is to get load balance between the 2 peers(on the ASBR) in the outgoing traffic and to redistribute only 0.0.0.0 to VRF INTERNET to all the IBGP peers. what i see now is that the 0.0.0.0 gets label in the FIB of the ASBR pointing on one of the POS interface, so the other POS stay empty , with the show ip route vrf INTERNET 0.0.0.0 0.0.0.0 command i see the LB0 of the ASBR which is OK but the MPLS label table on the VRF INTERNET is pointing on the POS interface . i just want that the ASBR will route the traffic according to his full route table . so actually now i redistribute to all PE's /20 subnets for getting load balance , does someone have a good ides for this one ? regards moshe _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/