I've NPE-G1 with 3k PPPoE & PPPoA and it uses only 40% CPU. It seems that you use 58% of the 80% CPU usage for ACL only if I'm not wrong (80%/58%) May be you can check your config about this ?
Alain Cocconi -----Message d'origine----- De : [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] De la part de E. Versaevel Envoyé : jeudi 4 décembre 2008 22:04 À : [email protected] Objet : [c-nsp] 7602VXR NPE-G1 Hello, I've got a 7206VXR with NPE-G1 configured for PPPoA termination, we recieve the VC's over an STM-1 and terminate them into various vrf's (for VPN) or into the global routing table (for internet). We are currently experiencing high cpu load (>80%) and some slow CLI access. We have about 2500 sessions on the box using up to 120 Mbit @ 30k packets/s CPU utilization for five seconds: 80%/58%; one minute: 84%; five minutes: 77% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 78 443181316-1276820381 0 6.12% 5.32% 4.89% 0 IP Input 247 449268424 641021686 700 2.86% 3.35% 3.41% 0 PPP Events Any idea on how we could debug the CPU usage ? We've got another 7200 doing only routing an that never tops 15% CPU usage... Kind regards, Erik Versaevel _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
