I have a 2851 that I am trying to configure for incoming nat (from Internet to the inside). I copied the configs from another router (not 2851) that is working fine. The only difference is that the inside interface is now on a VLAN.
An extract of the config is below: Any ideas welcome --------------- interface GigabitEthernet0/0 description Internet ip address 66.zz.zz.zz 255.255.255.240 ip nat outside ip virtual-reassembly duplex auto speed auto ! interface GigabitEthernet0/1 no ip address ip nat inside ip virtual-reassembly duplex auto speed auto ! interface GigabitEthernet0/1.50 encapsulation dot1Q 50 ip address 172.21.xx.xx 255.255.255.0 ip nat inside ip virtual-reassembly no snmp trap link-status ip nat inside source static tcp 172.21.xx.xx 22 62.zz.zz.zz 3673 extendable ip nat inside source static tcp 172.21.yy.yy 22 62.zz.zz.zz 3674 extendable _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
