This is not always the case (especially when both routers and switches are
involved).
I have seen many times this A|B|C etherchannels created without any obvious
reason.
And if you shut/no shut the member interfaces, the normal etherchannel is
created fine.
--
Tassos
Engelhard Labiro wrote on 22/01/2009 03:48:
This happen when you have a mismatch configuration between your
"Port-channel interface" setting and Gigabit interfaces which are
members of that Port-channel.
Compare again the settings in Port-channel and its members. All must
be the same otherwise you will get several port-channels w/ alphabet
assigned :D
On Thu, Jan 22, 2009 at 9:26 AM, Thilak T <[email protected]> wrote:
can anyone please advice what does it mean and why is an LACP port-channel
displays an alphabet along with an actual channel number ?
240 Po240(SD) LACP
240 Po240A(SU) LACP Gi10/17(P) Gi10/18(P) Gi10/19(P) Gi10/20(P)
240 Po240C(SU) LACP Gi10/21(P)
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
