Oki thanks, Then I just need to make sure that the switch between the router & the circuit can be changed to minimum 1504 system mtu right?
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Pelle Sent: jeudi 5 février 2009 14:58 To: c-nsp Subject: Re: [c-nsp] Ethernet VPN circuits Hi. > 2) Can I pass the double tag through my switch to our 7206 and configure a > double dot1q [outer tag].[inner tag] on my subinterface ? Yes, but of course it depends on the IOS you are running. >From a 7206VXR/NPE-G2 running SRC2: lotta(config)#int GigabitEthernet0/2.123123 lotta(config-subif)#encapsulation dot1Q 123 ? native Make this as native vlan second-dot1q Configure this subinterface as a 1Q-in-1Q subinterface <cr> lotta(config-subif)#encapsulation dot1Q 123 second-dot1q 123 ? <cr> -- Pelle _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
