Hello,
UDLD is a Layer2 protocol, so EoMPLS transports all UDLD frames coming
from CE. You should disable udld PE's interfaces connected to CE devices.
BR, A.
On Thu, 19 Feb 2009, Ruben Montes (Europe) wrote:
Hi,
We're already running 12.2(18)SXF11.
I have udld enabled for the whole box, do you mean that I must
explicitly disable udld in the interfaces on the PE switches where I
have created the VC with x-connect?
Thanks in advance,
Ruben
-----Original Message-----
From: BALLA Attila [mailto:[email protected]]
Sent: jueves, 19 de febrero de 2009 17:00
To: Ruben Montes (Europe)
Cc: [email protected]
Subject: Re: [c-nsp] UDLD is err-disabling EoMPLS VC
I had the same issue, it must be CSCsh99351, it is fixed in
12.2(18)SXF11.
You should use udld on ce uplinks only.
BR, A.
On Thu, 19 Feb 2009, Ruben Montes (Europe) wrote:
Hi,
We have configured a new EoMPLS VC. After 3 or 5 pings, UDLD
err-disables one of the interfaces. We are using port mode, is it
recommended to run such a a feature in this type of connections?
All the path has MPLS enabled and jumbo MTU enabled.
Thanks in advance,
Ruben
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
