The F0/0 interface on the 2651 is configured for 198.70.224.117/30, yet you're routing 198.70.33.176/29 to them. Is there NAT'ing going on, or did I miss something?
Ken Matlock Network Analyst Exempla Healthcare (303) 467-4671 [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Todd Shipway Sent: Monday, February 23, 2009 2:07 PM To: [email protected] Subject: [c-nsp] Small routing issue I'm working on a small issue that I just can't track down. The connection is 2 T1's bonded in a multilink interface. Connection within the core network is fine from the remote end, but the traffic will not make it to the default route on the core 7513. Hundreds of other connections are setup absolutely identical and work fine. Default route is fine and debugging doesn't show anything at all. Config is below: 7513 (Core) interface Multilink68 ip address 10.10.58.1 255.255.255.252 ppp chap hostname group68 ppp multilink ppp multilink fragment disable ppp multilink group 68 interface Serial9/0/0:1 no ip address encapsulation ppp ppp chap hostname group68 ppp multilink ppp multilink group 68 ! interface Serial9/0/0:2 no ip address no ip unreachables encapsulation ppp ppp chap hostname group68 ppp multilink ppp multilink group 68 ip route 198.70.33.176 255.255.255.248 10.10.58.2 2651 (Remote End) interface Multilink68 ip address 10.10.58.2 255.255.255.252 ppp chap hostname group68 ppp multilink ppp multilink fragment disable ppp multilink group 68 ! interface FastEthernet0/0 ip address 198.70.224.117 255.255.255.252 duplex auto speed auto ! interface Serial0/0 bandwidth 1540 no ip address encapsulation ppp fair-queue ppp chap hostname group68 ppp multilink ppp multilink group 68 interface Serial0/1 bandwidth 1540 no ip address encapsulation ppp ppp chap hostname group68 ppp multilink ppp multilink group 68 ip route 0.0.0.0 0.0.0.0 Multilink68 #ping 10.10.53.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.10.53.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms ping 74.125.45.100 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 74.125.45.100, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) trace 74.125.45.100 Type escape sequence to abort. Tracing the route to yx-in-f100.google.com (74.125.45.100) 1 10.10.58.1 4 msec 4 msec 4 msec 2 * * * 'debug ip icmp' shows nothing on 10.10.58.1 when pinging outside. Core network is 10.10.x.x and remote end can ping anything within the core network or anything within our infrastructure. Will not ping anything outside the network. Seems like a routing issue, but I can't seem to track it down. Any idea as to what to look for or how to pinpoint a deeper routing issue? Any help would be appreciated. -Todd _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
