Does the Sup have Rommon 7.1(1) on it? Otherwise, it won't understand the 64MB ATA card. I believe that's the only one that shows up as disk0:. The smaller ones aren't ATA, so they're linear and show up as slot0:. Did you try verify slavedisk0:filename?
Chuck -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Alex Wa Sent: Wednesday, February 25, 2009 11:46 AM To: lista de correo de cisco Subject: [c-nsp] flash disk problem Hi guys I copied a file to slavedisk0: on a 6513-sup II board. when I try to use verify slaveslot0:filename I get this error output %Error verifying slaveslot0:c6sup22-jk2sv-mz.121-22.E2.bin (Bad file number) the disk was formatted in this switch and the file copied without problems. The issue is that i'm trying to upgrade the IOS to the new one in flash and it can't load. I also would like to know the difference between disk0: and slot0:, i don't fully understand it, if any. thanks in advance Alejandro _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
