While this does not answer any questions, A lot of these fairly basic types of questions can quickly and easily be lab'ed up using Dynamips/GNS3. It's well worth the minimal time and effort to get either of those running and build yourself a basic network topology.
Online vendor documentation (and I understand that some documentation can be difficult to comprehend, no sarcasm intended) is often helpful but sometimes can be overwhelming especially if you're just starting out. In these cases, trial and error with a virtual/physical lab pays big dividends. In these days, who doesn't want dividends? The upside to a lab is that you get to test whether a suggested config actually works before you deploy it. "Give a man a fish and you feed him for a day. Teach a man to fish and you feed him for a lifetime" Vijay Ramcharan -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Steve Howes Sent: February 27, 2009 11:36 To: [email protected] Subject: Re: [c-nsp] NAT and vlan works? On 27 Feb 2009, at 12:03, ann kok wrote: > > Hi > > I want to configure 802.1q 3 vlans and router NAT > > eth1 as > > 192.168.1.0/24 vlan2 > > 192.168.2.0/24 vlan3 .... > > 192.168.3.0/24 vlan4 > > eth0 is public > > Can it work? > > How can I configure? Define the insides as insides, the outside as outside... configure the nat rule... plenty of documentation.. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
