Hi all,
I am banging my head against the wall with a particular route-map, and I'm
seriously wondering if I drank the stupidity kool-aid today. I'm testing a
route-map between two BGP speakers, a 7600 running 12.2(33)SRC1 and an ME6524
running 12.2(33)SXI, and for the life of me I cannot get either to match based
on a defined community. The matching is done for inbound prefixes. Outbound
prefixes from the peer are not filtered, and are visible as (received) when
soft-reconfiguration is configured. The specific community below is one of
several that may accompany a route.
Here is a sample, stripping out the identifying details:
(two sample routes, 1.1.1.0/24 and 2.2.2.0/24)
- snip -
ip community-list TEST-COMMUNITY 65000:1234
ip prefix-list TEST-PREFIX-LIST permit 1.1.1.1/24
route-map TEST-IN permit 100
match ip address prefix-list TEST-PREFIX-LIST
route-map TEST-IN permit 200
match community TEST-COMMUNITY
set local-pref 90
route-map TEST-IN deny 999
desc The End.
- snip -
The first route, 1.1.1.1/24 is received and entered into the RIB successfully.
The second, which should be matched based on community, is not. It is listed as
received, but that's all.
What the heck am I missing?
-- Stephen
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
