Seems that all cards and in all slots seem to fail. Again, the same cards work fine else were.
On Mon, Mar 16, 2009 at 6:47 PM, Phil Mayers <[email protected]>wrote: > On Mon, Mar 16, 2009 at 07:40:30PM +0000, Jimmy Changa wrote: > >> I have a 6500 with a sup720-3BXL. Every time I put a WS-X6408A-GBIC card >> in >> the chassis, diag fails the card. >> >> I haven't rebooted the box yet, as this carrys a significant amount of >> traffic, has anyone else seen this type of problem. >> >> Diag on the most recent card shows: >> >> 7) TestUnusedPortLoopback: >> >> Port 1 2 3 4 5 6 7 8 >> ---------------------------- >> U U U F U U U F >> > > Some of the diags are heavily dependent on IOS config, usually only the > disruptive ones though. I don't have any 6408s but what does: > > sh diagnostic content module X > > ....say when the card is inserted? It should list some details about test > #7 i.e. whether it's a bootup/health test, which I'd expect to pass in all > circumstances. > > A few weeks ago, I'd have said you may have a bad slot, but recently we had > a slot "go funny" and no amount of fiddling would clear it *except* a reload > of the box, so it's definitely worth trying. > > >> The cards work in other chassis. >> > > Have you tried other cards in that slot? > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
