Hi guys,
We're receiving this log message when trying to apply a vlan filter to a RSPAN
VLAN.
Apr 10 13:36:08.580: %FM-4-TCAM_ENTRY: Hardware TCAM entry capacity exceeded
Apr 10 13:36:08.580: %FM-2-VACL_FAILURE: Interface Vlan100 traffic will not
comply with VACLs in ingress direction(s)
We don't have any access list applied to any interface except the VLAN filter ,
and in total 16 access-lists. the sh tcam counts is below (when the output was
taken the vlan filter wasn't applied)
Used Free Percent Used Reserved
---- ---- ------------ --------
Labels: 2 510 0
ACL_TCAM
Masks: 2 4094 0 0
Entries: 16 32752 0 0
QOS_TCAM
Masks: 0 4096 0 0
Entries: 0 32768 0 0
LOU: 0 64 0
ANDOR: 0 16 0
ORAND: 1 15 6
ADJ: 0 1024 0
Cisco's error decoder recomends to delete unused access list but we can't
reduce no more and 16 acess lists is a normal, if not low, amount .
any hint ?
thanks in advance,
Alejandro Wainshtok
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
