It doesn't.
I so wish it did, but no dice.
On 15-Apr-09, at 5:36 AM, Adrian Minta wrote:
According to "Cisco ME 3400 data sheet" http://tinyurl.com/yphgj5
the switch support uRPF with METROIPACCESS image, but I get the
following error:
switch(config)#interface GigabitEthernet0/2
switch(config-if)#ip verify unicast reverse-path
% ip verify configuration not supported on interface Gi0/2
- verification not supported by hardware
Does anyone knows the magic needed to make uRPF work on this switch ?
System image file is "flash:me340x-metroipaccess-mz.122-40.SE/me340x-
metroipaccess-mz.122-40.SE.bin"
cisco ME-3400G-12CS-A (PowerPC405) processor (revision C0) with
118784K/12280K bytes of memory.
Interface GigabitEthernet0/2 is in routed mode (no switchport).
--
Best regards,
Adrian Minta
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
