Hi all, I don't know if this is even possible but I'll try and make it work none the less!
I am trying to bridge 4 vlans (reduced to 2 vlans for now to get working) together on a 3560 to allow a sudo transparent transport for a customer. The VLANs are delivered to me from a third party provider as dot1q vlans and all arrive on the same trunk port on the 3560. I have created the VLAN and SVI for each connection. In each SVI I have added bridge-group 2 to the configuration to each of the 4 svi's I would like to see bridged. I have bridge 2 protocol vlan-bridge configured as well as bridge irb in the configuration. The customer has a flat network of 192.168.0.x/24 configured on their equipment at each site and need to contact a host at site A. I am not able to get any response from each end point via the bridge, but if I place an IP on the SVI, I can pass traffic on each separate SVI. Mac addresses only appear on each vlan and not on the bridge group. # show bridge 2 group Bridge Group 2 is running the VLAN Bridge compatible Spanning Tree protocol Port 2280 (Vlan212) of bridge group 2 is forwarding Port 2282 (Vlan214) of bridge group 2 is forwarding interface Vlan212 no ip address bridge-group 2 end ! interface Vlan214 no ip address bridge-group 2 end Any idea's where I should start looking for clues? Regards, Jeff. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
