can you please display same reorder stats on customer side? On Thu, Jul 16, 2009 at 4:19 AM, Rodney Dunn <[email protected]> wrote:
> Depending on your apps ability to handle out of order frames on the end > stations of course. > > On Wed, Jul 15, 2009 at 09:59:04PM -0400, Rodney Dunn wrote: > > I bet your out of order is getting so bad you are dropping the packets. > > > > I'm not a PPPox expert...but could you create 7 dialers and do CEF > > per packet over them? > > > > On Wed, Jul 15, 2009 at 10:07:24AM -0500, Dave Weis wrote: > > > > > > I'm bringing up a MLPPP PPPoA bundle with 4 7-meg DSL lines. It had > worked > > > fine with only 2 lines in the bundle and provided the full expected > speed. > > > Adding the next two lines didn't provide an increase in speed, it > actually > > > might have decreased a bit. It tops out at around 10 megabits with 4 > links > > > in the bundle. > > > > > > The hardware on the customer side is a 3745 running 12.4(4)T1. It has 4 > > > WIC-1ADSL's installed. The config on the ADSL interfaces are all > > > identical: > > > > > > interface ATM0/0 > > > no ip address > > > no atm ilmi-keepalive > > > dsl operating-mode auto > > > hold-queue 224 in > > > pvc 0/32 > > > encapsulation aal5mux ppp dialer > > > dialer pool-member 1 > > > ! > > > > > > interface Dialer0 > > > ip address negotiated > > > no ip proxy-arp > > > encapsulation ppp > > > dialer pool 1 > > > dialer vpdn > > > dialer-group 1 > > > ppp pap sent-username <removed> > > > ppp link reorders > > > ppp multilink > > > ppp multilink fragment disable > > > ! > > > > > > We've tried it with and without the reorders and fragment changes in > the > > > config. > > > > > > The server side is a 7206 with an NPE-G1. We're not topping out the > > > processor on either side during transfers. > > > > > > The multilink bundle shows a lot of discards and reorders. This is > after a > > > reset and downloading less than a gig of data on the client: > > > > > > Virtual-Access3, bundle name is isprouter > > > Endpoint discriminator is isprouter > > > Bundle up for 01:15:43, total bandwidth 400000, load 1/255 > > > Receive buffer limit 48768 bytes, frag timeout 1000 ms > > > Using relaxed lost fragment detection algorithm. > > > Dialer interface is Dialer0 > > > 0/0 fragments/bytes in reassembly list > > > 242 lost fragments, 1237543 reordered > > > 29169/15194784 discarded fragments/bytes, 16700 lost received > > > 0x1F9178 received sequence, 0x6A517 sent sequence > > > Member links: 4 (max not set, min not set) > > > Vi4, since 01:15:43, unsequenced > > > PPPoATM link, ATM PVC 0/32 on ATM0/0 > > > Packets in ATM PVC Holdq: 0, Particles in ATM PVC Tx Ring: 0 > > > Vi6, since 01:15:43, unsequenced > > > PPPoATM link, ATM PVC 0/32 on ATM1/0 > > > Packets in ATM PVC Holdq: 0, Particles in ATM PVC Tx Ring: 0 > > > Vi5, since 01:15:43, unsequenced > > > PPPoATM link, ATM PVC 0/32 on ATM0/2 > > > Packets in ATM PVC Holdq: 0, Particles in ATM PVC Tx Ring: 0 > > > Vi2, since 01:15:43, unsequenced > > > PPPoATM link, ATM PVC 0/32 on ATM0/1 > > > Packets in ATM PVC Holdq: 0, Particles in ATM PVC Tx Ring: 0 > > > No inactive multilink interfaces > > > > > > > > > Any ideas to get this closer to 20+ megs? > > > > > > THanks > > > dave > > > > > > > > > > > > > > > -- > > > Dave Weis > > > [email protected] > > > http://www.internetsolver.com/ > > > > > > _______________________________________________ > > > cisco-nsp mailing list [email protected] > > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
