Ryan West wrote:
Justin,
Give this a shot:
http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2&mibName=CISCO-ICSUDSU-MIB
That MIB contains values for different loop codes.
Ryan,
That looks like a very useful MIB. I'll give that a try.
I looked at the source of the check_snmp_int.pl script for Nagios as
well and noticed that it was built to handle 3 response codes: up, down
and testing. On a hunch I looped up an unused T1 on a T3 controller and
hit it with a snmpwalk. Sure enough it listed the looped interface as
"testing":
IF-MIB::ifOperStatus.28 = INTEGER: testing(3)
check_snmp_int.pl also correctly detected the situation:
Serial1/0/10:0:TESTING: 1 int NOK : CRITICAL
So it looks like that plugin will do what I need if I can figure out how
to make it only give a warning if the interface is in testing and not a
critical alarm (warning for say 1hr; then escalate it send our alerts).
I want it to warn with no email for about an hour. Then escalate it
and send our the alerts. Should be doable.
Thanks
Justin
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
