show bridge group On Tue, Jul 28, 2009 at 1:22 PM, Daniel Garrido <[email protected]> wrote:
> Hi, > > I have two 6500 in a LAN connected at layer 2. > Each of them have a SVI with an IP and HSRP working without problems. > When I configure "Fallback Bridging" in the SVI in both switches, HSRP stop > working, > so I think the problem can be related to a segmented L2 network topology. > > I found the following link: > > http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00800a7af6.shtml > > The questions is: How can I check the STP state of the ports connecting to > the MSFC? > > The configuration in both switches is like the following: > > interface VlanXX > ip address X.X.X.X 255.255.255.0 > standby 28 ip X.X.X.Y > bridge-group 1 > > bridge 1 protocol vlan-bridge > bridge 1 priority 20000 > > Best regards. > > -- > Daniel > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
