Hi Guys,
Our T3 controller is down and the SP has asked me what I am seeing on my
end. Below is the show controllers command on my router. Could you tell
me where the problem is based on the output below?
Router#sh controllers t3
T3 3/0 is down.
Applique type is Subrate T3
Description: Carrier_Circuit_ID
Transmitter is sending remote alarm.
Receiver is getting AIS.
MDL transmission is disabled
FEAC code received: No code is being received
Framing is C-BIT Parity, Line Code is B3ZS, Clock Source is Line
Data in current interval (250 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
250 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Cheers,
K
CB Richard Ellis Limited, Registered Office: St Martin's Court,
10 Paternoster Row, London, EC4M 7HP, registered in England and Wales No.
3536032.
Regulated by the RICS and an appointed representative of CB Richard Ellis
Indirect Investment Services Limited which is authorised and regulated by the
Financial Services Authority.
This communication is from CB Richard Ellis Limited or one of its
associated/subsidiary companies. This communication contains information
which is confidential and may be privileged. If you are not the intended
recipient,
please contact the sender immediately. Any use of its contents is strictly
prohibited
and you must not copy, send or disclose it, or rely on its contents in any way
whatsoever.
Reasonable care has been taken to ensure that this communication
(and any attachments or hyperlinks contained within it) is free from computer
viruses.
No responsibility is accepted by CB Richard Ellis Limited or its
associated/subsidiary
companies and the recipient should carry out any appropriate virus checks.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
