Thanks Arie, I was trying to do a port that is trunked then apply port-security. I think this doesn't give the option. The only next thing to do perhaps is to try it with access-list or pvlan? But the the thing with pvlan is, will it complicate the config using other vlans on top of that?
regards, chris On Tue, Sep 8, 2009 at 4:02 PM, Arie Vayner (avayner) <[email protected]>wrote: > Chris, > > This is the latest config guide: > http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/52sg/conf > iguration/guide/port_sec.html<http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/52sg/conf%0Aiguration/guide/port_sec.html> > > Could be some older IOS or low end SUP? > > Arie > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Dracul > Sent: Tuesday, September 08, 2009 10:51 > To: [email protected] > Subject: [c-nsp] cisco 4503 port security > > Hi List, > > has anybody experienced doing port isolation / port-security using the > cisco > 4503? > I can't seem to find the best way to do it since the IOS doesn't have > port-security option in the CLI. > > regards, > Chris > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
