I'm trying to figure out of the Catalyst 4500s running Sup5 with IOS
12.2SG support the carrier-delay command. The interface capabilities
show that the old Catalyst link debounce feature isn't supported on
WS-X4306 GigE interfaces , however the switch allows you to configure
carrier-delay. For example:
conf t
interface g5/5
carrier-delay msec 100
end
According to the 12.2(46)SG configuration guide, you can only configure
link debounce on 10GE interfaces. I can't find any references to
support for carrier-delay.
*http://tinyurl.com/m7wvfs*
switch# show int g4/4 cap
GigabitEthernet4/4
Model: WS-X4306-GB-Gbic
Type: 1000BaseLH
Speed: 1000
Duplex: full
Auto-MDIX: no
Trunk encap. type: 802.1Q,ISL
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression: percentage(0-100), hw
Flowcontrol: rx-(off,on,desired),tx-(off,on,desired)
VLAN Membership: static, dynamic
Fast Start: yes
Queuing: rx-(N/A), tx-(1p3q1t, Sharing/Shaping)
CoS rewrite: yes
ToS rewrite: yes
Inline power: no
SPAN: source/destination
UDLD: yes
Link Debounce: no
Link Debounce Time: no
Port Security: yes
Dot1x: yes
Maximum MTU: 9198 bytes (Jumbo Frames)
Multiple Media Types: no
Diagnostic Monitoring: no
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
