Hi Chris,
I reloaded the box this morning, but I'll configure the command in order
to prevent further issues :)
Thanks:)
Chris Mason (chrimaso) wrote:
Hi Mihai,
Check out CSCsz68307 - this occurs when someone attempts to configure an invalid IP
address as a BGP peer - after that you are unable to create any additional peers as you
get the error message "*% Create the peer-group first".
To resolve the problem you either need to reload the box or configure "no parser
cache" - the latter being more preferable.
Hope that helps,
Chris
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Mihai Campean
Sent: 14 September 2009 14:34
To: [email protected]
Subject: [c-nsp] Problems creating a new BGP neighbor
Hi,
today I tried to create a new bgp neighbor, and the following message
was prompted:
router1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
router1(config)#router bgp 1235
router1(config-router)#neighbor 1.2.3.5 remote-as 1235
*% Create the peer-group first
*Has anyone encountered this?
The machine is a 7600 series router, running Cisco IOS Software,
c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICES-M), Version
12.2(33)SRC1, RELEASE SOFTWARE (fc1)
Any ideea if this is a known BUG, and if there is some command on the
IOS that forces you to add a new neighbor to a peer-group?
Thanks,
--
Best regards,
----------
Mihai Campean
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
