Drew, You should have a crashinfo file on the used-to-be-primary SUP bootflash. The right thing would be to open a TAC case, and give the engineer the crashinfo file and the show tech for the device.
Arie -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Drew Weaver Sent: Tuesday, September 22, 2009 21:38 To: [email protected] Subject: [c-nsp] 6500 - stateful failover, reason? Is there any way to get more information about what caused a fail-over between two supervisors in a 6500? All I can appear to get is "Active crashed." from show redundancy switchover and my syslog doesn't have any information either. Also, is it normal that during switchover you will lose protocols (OSPF) and that you will see messages like these in the log? Sep 22 08:41:17.651 EDT: %C6KPWR-SP-4-PSOK: power supply 1 turned on. Sep 22 08:41:17.699 EDT: %C6KPWR-SP-4-PSOK: power supply 2 turned on. The log messages sort of confuse me because show version indicates: uptime is 10 weeks, 4 days, 1 hour, 35 minutes So it's been up 10 weeks but the power supplies were just turned on < 12 hours ago? I assume that is just random log-spew from the hot-supervisor taking over, though? -Drew _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
