Marian Ďurkovič wrote:
On Fri, Oct 16, 2009 at 12:06:39PM +0100, Phil Mayers wrote:
Aren't Cisco switches supposed to send BPDUs also to IEEE STP MAC address
Generally, no. Vlan 1 is treated specially.
on 802.1Q trunks? Or is there any special config needed for this?
Vlan number 1 will interop, so if you do this:
int Gi1/1
switchport mode trunk
switchport trunk native vlan 1
switchport trunk allowed vlan 1,2,3
...then vlan 1 will form an 802.1w adjacency with the neighbour, vlans 2
and 3 will just pass straight through it.
Is that ultimately limited to vlan #1, or could it be done with the native
vlan on trunk (e.g. vlan #1520) as well?
vlan #1 as far as I know.
We're removing vlan #1 from all trunks by principle for obvious reasons...
Sure. It's not a very useful feature ;o)
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
