Dear all
i have 5 giga ethernet interfaces connected via port channel to WiMAX ASN
gateway
the device is cisco CISCO7606-S with IOS
c7600s72033-advipservicesk9-mz.122-33.SRB2.bin
when i issue the command sh run int po20
interface Port-channel20
switchport
switchport access vlan 20
switchport trunk encapsulation dot1q
switchport mode access
flowcontrol receive on
flowcontrol send on
end
sh int po20 | inc flow
input flow-control is off, output flow-control is off
does that mean that the other device dont support flow control ? or i need
something else to enable flow control ?
because i suffer from overruns on the port channel ? is that the problem ?
Thanks in advance
_________________________________________________________________
Windows Live: Keep your friends up to date with what you do online.
http://www.microsoft.com/middleeast/windows/windowslive/see-it-in-action/social-network-basics.aspx?ocid=PID23461::T:WLMTAGL:ON:WL:en-xm:SI_SB_1:092010
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
