On Tuesday 24 November 2009 04:36:58 am Jared Mauch wrote: > Cisco does not have a coherent config order that will be > output.
Like when we moved from SRC3 to SRC5 earlier this month, RANCID
reported minor but strange changes to the configuration order,
e.g., the 'police' command under a policy-map has been given one
extra <TAB> indent. This looks very weird if you also have a 'set
mpls experimental' command right above it because it now looks like
the 'police' command is a sub-command of the 'set mpls experimental'
command:
policy-map XXX-XXX-XXX-60Mbps
description XXX XXX XXX
class XXX-XXX-XXX
set dscp 63
set mpls experimental imposition 0
police cir 60000000 bc 11250000 be 22500000 conform-action transmit
exceed-action drop violate-action drop
Previously, as in the case of moving from SXH3 to SXI2a also, IPv6
static routing and ACL commands keep moving up and down the
configuration.
I wouldn't be surprised if this has been noticed and gets
fixed in SRC6 or later, and then we have RANCID crying all over
again.
Mark.
signature.asc
Description: This is a digitally signed message part.
_______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
