Hello Gents,
I have a 2621 with VWIC-2MFT-E1 module. In "sh ip int br" under the serial
interface I have protocol status "reset". Under "show controllers E1" I have
"Receiver is getting AIS" but on the transmission equipment I see an error
"loss of signal" which indicates problem with the patch. The field engineer
checked the patch, looped it and the port went up but as soon as we connect it
back to the ADM it goes to reset.
Regards,
Kamen
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
