Well you can use Stateless DHCP for handing out DNS,SIP,NTP,etc.. , and there is the following command for DHCP relay services under the interface config:
ipv6 dhcp relay destination X:X:X:X::X > From: [email protected] > Date: Fri, 11 Dec 2009 15:52:09 +0000 > To: [email protected] > Subject: [c-nsp] IPV6 > > It's been a while since I worked with IPV6 and I am now once again plunging > myself into this feckless world and was wondering if a couple of holes had > now been plugged. What is the accepted way in IPV6 land to dish out IPV6 DNS > server addresses (am I correct in saying that if you make use of NDP, you > would still have to manually configure DNS servers)? The other hole, as was, > is the lack of IPV6 help address functionality on Cisco routers (well 6500s > at least): if I were to go down the route of using DHCP for IPV6, how could I > use a central server without this helper functionality? > > Ta. > > > Michael > -- > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _________________________________________________________________ Hotmail: Free, trusted and rich email service. http://clk.atdmt.com/GBL/go/171222984/direct/01/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
